Yes — if it's actually screwed into studs or proper anchors, not stuck on. Our corner caddy is load-rated to 44 lb (20 kg), and that rating assumes the included anchors and screws are installed per the instructions. The shelf itself is fully welded SUS304 stainless with zero plastic load-bearing parts, so the weak point is your wall, not the hardware.
How do I mount it in a rental bathroom without wrecking the tiles?
This is the question I get most at OkaNest, and I understand it. Drilling into a rental feels risky. Here's how I walk people through it:
- Check your corner angle first. The caddy fits any 90-degree shower corner. If your walls meet at some other angle, it won't sit flush — measure before anything else.
- Confirm the footprint. It's 12.2 in wide (31 cm), 9.1 in deep (23 cm), and 2.4 in tall (6 cm). Hold a tape measure in the corner at the height you want and make sure nothing (shower head, glass door swing) collides.
- Find the studs or use the anchors. Screwing into a stud is strongest. Where there's no stud, the included anchors carry the load — that's what the 44 lb rating is based on.
- Drill tile carefully. Use a masonry bit, start with tape over the spot to stop the bit wandering, and keep the drill slow so you don't crack the glaze. Small holes are easy to patch with grout or silicone at move-out.
- Mind the weight. 44 lb is generous for bottles, but it's a ceiling, not a target. Spread weight evenly across the shelf.
One honest note: if your lease forbids any drilling, this isn't the product for you. I'd rather tell you that than have you patch four holes later.
Screw-mounted stainless vs. suction cup vs. adhesive — which should you pick?
I've used all three, and each wins in a different situation.
Suction cup caddies win only when you truly cannot drill and your tile is smooth and non-porous. They're cheap and removable. But suction fails with heat, steam, and textured tile — ours let go at 2am, which is exactly why we stopped selling that style as a primary option. If your shower gets steamy and your bottles are heavy, skip them.
Adhesive (glue) mounts win for renters who want zero holes and light loads. They hold better than suction on clean, flat tile, but they still rely on a bond that ages with moisture, and removing them can pull coating or leave residue. Fine for a bar of soap and a loofah; not what I'd trust with a full family's bottles.
Screw-mounted SUS304 wins when you want it to stay put for years. Real 304 stainless resists the orange rust we saw on that coated plastic shelf, and the welded frame has no plastic parts to snap. You pay in installation effort — 15 minutes and a drill — and in the fact that it's semi-permanent. For a home you own, or a rental where small patched holes are acceptable, this is the one I recommend. Three finishes (Polished Stainless, Matte Black, Gunmetal Grey) let you match your fixtures instead of adding another mismatched chrome blob.
Quick takeaways
- 44 lb (20 kg) rating holds only with the included screws and anchors properly set — the wall is the weak link, not the welded SUS304 frame.
- Measure your corner angle (must be 90°) and the 12.2 × 9.1 × 2.4 in footprint before drilling.
- No drilling allowed? Choose adhesive for light loads; choose screw-mount when you want it to stay for years.
Q: Can a screw-mounted shower caddy really hold 44 lb?
A: Yes, when installed with the included anchors and screws into a solid wall or studs — that's the condition the 44 lb (20 kg) rating is based on. The fully welded SUS304 frame has no plastic load-bearing parts, so failure points are the wall and installation, not the shelf.
Q: How do I mount it in a rental bathroom without wrecking the tiles?
A: Check that your corner is a true 90 degrees and that the 12.2 in wide, 9.1 in deep footprint clears your shower head and door, then drill small holes with a masonry bit and patch them with grout at move-out. If your lease bans drilling entirely, this mount isn't the right fit — adhesive is your alternative.
Q: Screw-mounted stainless vs. suction cup vs. adhesive — which should you pick?
A: Suction wins only on smooth tile with light loads and no drilling allowed; adhesive suits renters with light items; screw-mounted SUS304 wins when you want a 44 lb-rated shelf that won't drop at 2am. For a home you own, I'd pick the screw mount every time.