Short answer: only if your base cabinet is 30 to 36 inches wide (76–91 cm) and has clearance around the drain trap. The SinkFlex Under Sink Pull Out Organizer is made for that range, and the pipe-wrap cut lets the basket sit around the drain pipe instead of bumping into it. If your cabinet is narrower than 30 inches or wider than 36, this 2-pack is not the right fit.
I rent a tiny kitchen and my under sink cabinet is full of pipes. How do I measure before ordering?
Renters ask me this constantly, because they can't drill into anything permanent and they don't want to buy twice. Here's the order I walk people through:
- Measure the inside width of the base cabinet, wall to wall, not the door opening. You need 30–36 in (76–91 cm).
- Look at the drain trap. Find the lowest point of the pipe drop and measure from the cabinet floor up to it. That tells you whether the Short or Tall variant clears it.
- Check the door. The baskets slide out, so the door has to open past the rail travel. A standard hinged door is fine; a drawer front that only tilts won't work.
- Measure depth from the back wall to the inside of the door. Leave room for the basket to pull out without hitting the frame.
- If a pipe sits dead center, the pipe-wrap cut handles it. If pipes cross the whole floor, no pull-out basket solves that — you'd need a shelf instead.
One more rental note: the 2-pack means you organize both sides of the cabinet at once, so you're not choosing which half gets storage.
Short vs Tall, or a plain shelf — which should I get?
Honest comparison, based on what people tell me after buying.
Short variant wins when your trap hangs low. You get a shallower basket that still slides out on real rails with a stop, so bottles don't tip when you pull. Good for cleaning sprays and sponges.
Tall variant wins when the pipe drop is high and you want vertical room for taller bottles. Same welded carbon steel frame, same rail system, just more height.
A plain wire shelf wins only if your pipes run across the entire cabinet floor. It's cheaper, but you'll still be reaching into the back corner, which is the exact complaint people bring to me about their old setup.
Cheap pull-outs lose on the rails. Shoppers consistently flag rails that fall apart or jam under weight. The SinkFlex uses fully welded carbon steel and slide rails with a stop, so the basket glides out and stays put instead of dropping.
If your cabinet is in the 30–36 in range and you have any usable floor space beside the trap, the 2-pack beats a shelf. If pipes cover everything, skip it.
Quick takeaways
- Fits standard base cabinets 30–36 in (76–91 cm) wide; not for narrower or wider cabinets.
- Choose Short or Tall based on your pipe drop — measure floor to the lowest pipe point first.
- Fully welded carbon steel with slide rails and a stop; the pipe-wrap cut works around the drain instead of fighting it.
Q: Can under sink pull out baskets fit small cabinets?
A: They fit base cabinets 30 to 36 inches wide (76–91 cm) with clearance for the trap. Anything narrower than 30 in or wider than 36 in won't work, so measure inside width first.
Q: I rent a tiny kitchen and my under sink cabinet is full of pipes. How do I measure before ordering?
A: Measure inside cabinet width (30–36 in), then floor-to-pipe-drop to pick Short or Tall. Check that your door opens past the rail travel, since the baskets slide out.
Q: Short vs Tall, or a plain shelf — which should I get?
A: Short for a low trap, Tall for a high pipe drop with taller bottles. A plain shelf only wins if pipes cover the whole cabinet floor; otherwise the 2-pack's welded rails and stop beat reaching into dead corners.
Outside the sink base, a standard floor-rail basket is the sturdier option, and the pull-out install guide uses the same width-and-depth check you just did.